LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Impala Base, 3.4 E >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System 3.4L (Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement (7X) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Lubricate the O-ring with clean engine oil before installation and replace the O-ring if necessary.
  2. Install the CKP sensor.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  4. Connect the CKP sensor electrical connector.
  5. Install the right front wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
  7. Perform the CKP system variation learn procedure. Refer to CKP System Variation Learn Procedure .
    8. Fig 1: View Of CKP Sensor (7X)
    GM15969Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals