LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Impala Base, 3.4 E >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System 3.4L (Introduction) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Valve Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install a new EGR valve gasket.
  2. Install the EGR valve.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the EGR valve bolts.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

  4. Install the EGR pipe to the EGR valve.
  5. Install the EGR pipe.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  6. Connect the EGR valve electrical connector.
    7. Fig 1: Installing EGR Valve
    GM507392Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals