Installation Procedure

NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

Install the accelerator controls cable bracket to the throttle body.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the accelerator controls cable bracket bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 1: Installing Accelerator Controls Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable (2) to the throttle body lever.
Install the accelerator cable (2) to the bracket (1).

Fig 2: Installing Accelerator Cable

Courtesy of GENERAL MOTORS CORP.

Install the cruise control cable (1) to the bracket (2).
Install the cruise control cable to the throttle body lever.

Fig 3: Installing Cruise Control Cable

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The throttle should operate freely, without binding, between full closed and wide open throttle.

Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.
Install the fuel injector sight shield. Refer toFuel Injector Sight Shield Replacement in Engine Mechanical - 3.8L.