April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

Attach the mechanics wire to the new cable.
Install the accelerator cable to vehicle using the routing verified during removal.

Fig 1: Accelerator Cable Routing

GM12715

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable through the cowl.
Remove the mechanics wire from the cable.

Fig 2: Installing Accelerator Cable Through Cowl

GM12262

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable (5) to the accelerator pedal lever (1).

Fig 3: Accelerator Cable & Components

GM12287

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable to the throttle body lever.

Fig 4: Installing Accelerator Cable To Throttle Body Lever

GM12265

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable to the accelerator cable bracket.

Fig 5: Installing Accelerator Cable To Accelerator Cable Bracket

GM12258

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable to the retaining clips.

Fig 6: Installing Accelerator Cable To Retaining Clips

GM12717

Courtesy of GENERAL MOTORS CORP.

Inspect for complete throttle opening and closing positions by operating the accelerator pedal. Inspect for proper carpet fit under the accelerator pedal.
Install the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.8L.