LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Impala SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System 3.8L (Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the right splash shield cover. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
  4. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement in Engine Mechanical-3.8L.
  5. Disconnect the crankshaft position (CKP) sensor electrical connector.
  6. Remove the CKP sensor shield (1).
    7. Fig 1: CKP Sensor Shield
    GM12302Courtesy of GENERAL MOTORS CORP.
  7. Remove the CKP sensor bolts.
  8. Remove the CKP sensor.
    9. Fig 2: CKP Sensor
    GM12303Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals