Installation Procedure
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
- Install the PCM to the PCM electrical connectors.
Tighten: Tighten the connectors to 8 N.m (71 lb in).
- Install the PCM and the wiring harness to the air cleaner housing assembly (3).
- Install the air cleaner housing cover (1).
- Install the air cleaner housing cover screws (2).
Tighten: Tighten the screws to 4 N.m (35 lb in).
- Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
- Install the left front inner fender brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
- The new PCM must be programmed. Refer to Service Programming System (SPS) in Programming.