LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Monte Carlo LS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System 3.4L (Introduction) >> Repair Instructions >> Accelerator Controls Cable Bracket Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the accelerator cable bracket to the throttle body.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut and the bolts to the accelerator cable bracket.

    Tighten: 

    • Tighten the nut to 10 N.m (89 lb in).
    • Tighten the bolts to 13 N.m (115 lb in).

    3. Fig 1: Installing Accelerator Cable Bracket
    GM12689Courtesy of GENERAL MOTORS CORP.
  3. Install the accelerator cable to the accelerator cable bracket.
  4. Install the accelerator cable to the throttle body lever.
    5. Fig 2: Installing Accelerator Cable
    GM12735Courtesy of GENERAL MOTORS CORP.
  5. Install the cruise control cable to the accelerator cable bracket.
  6. Install the cruise control cable to the throttle body lever.
  7. Inspect for complete throttle opening and closing positions by operating the accelerator pedal.
  8. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
    9. Fig 3: Installing Cruise Control Cable
    GM319387Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals