Keyless Entry Does Not Program
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check - Keyless Entry? | Go to Step 2 | Go to Diagnostic System Check - Remote Keyless Entry |
| 2 | Press each button of the transmitter one at a time. Does the system operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Lock and unlock the door locks using the controls inside the vehicle. Do the locks operate properly? |
Go to Step 4 | Go to Symptoms - Doors in Doors |
| 4 |
IMPORTANT:
Inspect that the keyless entry transmitter is the correct model for the vehicle remote system. A wrong model transmitter may pass this test, but will not activate the vehicle remote system.
|
Go to Step 9 | Go to Step 5 |
| 5 | Do any of the buttons on the transmitter sound the tone and illuminate the green light when pressed? | Go to Step 8 | Go to Step 6 |
| 6 | Replace the transmitter battery. Did you complete the replacement? |
Go to Step 7 | System OK |
| 7 |
|
Go to Step 9 | Go to Step 8 |
| 8 | Replace the transmitter. Did you complete the replacement? |
Go to Step 10 | System OK |
| 9 | Operate the transmitter with range of the vehicle. Does all of the remote function actuator (RFA) functions operate normally? |
Go to Step 12 | Go to Step 10 |
| 10 | Perform the programming procedure. Refer to Remote Control Door Lock Transmitter Programming (Scan 100) or Remote Control Door Lock Transmitter Programming (Tech 2) or Remote Control Door Lock Transmitter Programming (Theft) . Did the lock cycle to lock then unlock? |
Go to Step 12 | Go to Step 11 |
| 11 |
IMPORTANT:
When replacing the remote control door lock receiver (RCDLR), perform the programming procedure. Replace the RCDLR. Refer to Remote Control Door Lock Receiver Replacement .Did you complete the replacement? |
Go to Step 12 | System OK |
| 12 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |