LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 4.8L, 5.3L, & 6.0L (Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

IMPORTANT: Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.
    Fig 1: Identifying MAP Sensor
    GM260159Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor (1). Push the MAP sensor down in order to engage the sensor into the retainer.
    2. Fig 2: View of Intake Manifold Sight Sheet
    GM1231427Courtesy of GENERAL MOTORS CORP.
  2. Connect the MAP sensor electrical connector.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the intake manifold sight shield.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals