LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Tracker 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.0L (Introduction) >> Repair Instructions >> Engine Coolant Temperature (ECT) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.
  1. Install ECT sensor (2) to the coolant housing (1).

    Tighten:  Tighten the ECT sensor to 15 N.m (11 lb ft).

  2. Connect the ECT sensor electrical connector (3).
  3. Fill the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
    4. Fig 1: View Of ECT Sensor, Electrical Connector & Coolant Housing
    GM451377Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals