LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Tracker 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.0L (Introduction) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
    2. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  2. Disconnect the negative battery cable.
    3. CAUTION: Refer to Vehicle Lifting Caution in Cautions and Notices.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Disconnect the fuel return hose (1) from the fuel return pipe by the fuel tank.
  5. Disconnect the fuel vapor hose (2) from the fuel vapor pipe by the fuel tank.
  6. Disconnect the fuel feed outlet hose from the fuel filter.
    7. Fig 1: View Of Hoses & Clamps
    GM410904Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the fuel vapor hose (3) from the fuel vapor pipe in the engine compartment.
  8. Disconnect the fuel return hose (4) from the fuel return pipe in the engine compartment.
  9. Disconnect the fuel feed hose (1) from the fuel feed pipe in the engine compartment.
  10. Disconnect the retaining clamp (2) from the fuel pipes.
    11. Fig 2: View Of Retaining Clamp & Fuel Vapor, Fuel Return & Fuel Feed Hoses
    GM410880Courtesy of GENERAL MOTORS CORP.
  11. Disconnect the retaining clamps (2) from the fuel pipes (1).
  12. Remove the fuel pipes (1) from the vehicle chassis.
    13. Fig 3: View Of Fuel Pipes & Retaining Clamps
    GM55191Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals