Installation Procedure
- Raise the fuel tank with a hydraulic jack to within approximately 31 cm (12 in) of the vehicle underbody.
- Connect the electrical connector (2) to the fuel tank sender assembly.
- Connect the electrical connector to the fuel tank pressure sensor.
- Connect the fuel tank breather hose to the fuel tank.
- Raise the fuel tank all the way to the vehicle chassis.
- Secure the fuel tank to the vehicle chassis with the 2 straps (1) and the 4 bolts (2).
Tighten: Tighten the strap bolts to 35 N.m (26 lb ft).
- Install the fuel tank shield to the vehicle chassis.
- Secure the fuel tank shield to the vehicle chassis with the 4 bolts (3).
Tighten: Tighten the bolts to 35 N.m (26 lb ft).
- Connect the fuel vapor hose (2) to the fuel vapor pipe.
- Connect the fuel return hose (1) to the fuel return pipe.
- Install the fuel filler hose to the fuel tank.
- Connect the vapor hose from the EVAP canister to the fuel tank.
- Connect the vapor hose from the EVAP canister air filter to the fuel tank.
- Connect the fuel feed inlet hose (2) to the fuel filter (1).
- Lower the vehicle.
- Refill the fuel tank.
- Inspect for fuel leaks.
- Connect the negative battery cable.
- Start the engine.
- Inspect for fuel leaks and repair as necessary.
NOTE:
Refer to Fastener Notice in Cautions and Notices.