LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Tracker 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.0L (Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Lubricate the seal on the MAP sensor vacuum port with clean engine oil.
  2. Install the MAP sensor (2) into the intake plenum.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Secure the MAP sensor to the intake plenum with the 2 bolts (1).

    Tighten:  Tighten the bolts to 3.5 N.m (30 lb in).

    4. Fig 1: View Of MAP Sensor & Attaching Bolts
    GM470743Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector (4) to the MAP sensor (1).
    5. Fig 2: View Of MAP Sensor & Electrical Connector
    GM455400Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals