Installation Procedure
- Install the fuel pipes (1) to the frame of the vehicle chassis.
- Secure the fuel pipes (1) with the retaining clamps (2).
- Install the rear driveshaft center support.
Tighten: Tighten the center support fasteners to 68 N.m (50 lb ft).
- Install the front exhaust pipe. Refer to Front Pipe Replacement (2.0L) in Engine Exhaust.
- Install the two post catalyst oxygen sensors. Refer to Heated Oxygen Sensor Replacement - Position 2 .
- Connect the front driveshaft to the front differential.
- Install the right rear upper control arm. Refer to Rear Axle Upper Control Arm Replacement in Rear Suspension.
- Install the EVAP canister. Refer to Evaporative Emission (EVAP) Canister Replacement .
- Install the fuel tank. Refer to Fuel Tank Replacement .
- Connect the fuel return hose (1) to the fuel return pipe by the fuel tank.
- Connect the fuel vapor hose (2) to the fuel vapor pipe by the fuel tank.
- Connect the fuel feed outlet hose at the fuel filter.
- Connect the fuel vapor hose (3) to the fuel vapor pipe at the engine compartment.
- Connect the fuel return hose (4) to the fuel return pipe at the engine compartment.
- Connect the fuel feed hose (1) to the fuel feed pipe at the engine compartment.
- Connect the retaining clamp (2) to the fuel pipes.
- Connect the negative battery cable.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
CAUTION:
Refer to Battery Disconnect Caution in Cautions and Notices.