LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.4L (Introduction) >> Repair Instructions >> Air Cleaner Intake Duct Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the air intake duct to the MAF sensor.
  2. Install the air intake duct to the throttle body and the air cleaner cover to the air cleaner assembly.
    3. Fig 1: Locating Air Cleaner Cover Clips
    GM763010Courtesy of GENERAL MOTORS CORP.
  3. Latch the air cleaner cover clips (1).
  4. Reconnect the MAF sensor electrical connector (2).
  5. Reconnect the vent tube to the air intake duct.
  6. Install the IAT sensor.
    7. Fig 2: Locating Air Cleaner Intake Duct Clamps
    GM763014Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Tighten the 2 intake air duct clamps (1).

    Tighten:  Tighten the intake air duct clamps to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals