LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Astro Van Cargo, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - (Introduction) Specifications & Repair Instructions >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

IMPORTANT: The CKP System Variation Learn Procedure will need to be performed whenever the crankshaft position (CKP) sensor is removed or replaced. Refer to CKP System Variation Learn Procedure .
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Identifying Steering Linkage Shield Mounting Bolts
    GM325346Courtesy of GENERAL MOTORS CORP.
  2. If the vehicle is equipped with the underbody shield package, then remove the steering linkage shield mounting bolts.
    3. Fig 2: View Of Steering Linkage Shield
    GM325348Courtesy of GENERAL MOTORS CORP.
  3. Remove the steering linkage shield.
    4. Fig 3: Identifying CKP Sensor Harness Connector
    GM10937Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the CKP sensor harness connector.
    5. Fig 4: View Of CKP Sensor Bolt
    GM10938Courtesy of GENERAL MOTORS CORP.
  5. Remove the CKP sensor mounting bolt.
    6. Fig 5: View Of CKP Sensor & Bolt
    GM11485Courtesy of GENERAL MOTORS CORP.
  6. Remove the CKP sensor.
scientia non olet · About LEMON Manuals