LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Corvette 2D Convertible, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) >> Repair Instructions >> Fuel Tank Crossover Tube/Hose Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Locating Air Inlet Hose
    GM903539Courtesy of GENERAL MOTORS CORP.
  1. Remove the driveline support assembly. Refer to Driveline Support Assembly Replacement (Manual Transmission) or Driveline Support Assembly Replacement (Automatic Transmission) in Propeller Shaft.
  2. Remove the crossover tube from the clamp located above the transmission.
  3. Disengage the left crossover tube connector position assurance (CPA) retainer by pulling the tab (1) outward and rotate.
    4. Fig 2: Locating Crossover Tube Collar
    GM903540Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The crossover tube CPA is released when the latch disengages from the tank connection groove.
  4. Rotate crossover tube collar (3) counterclockwise to disengage.
    5. Fig 3: View Of Crossover Tube
    GM903557Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the crossover tube from the left fuel tank by pulling the tube straight out of the fuel tank connection.
  6. Repeat steps 3 through 5 for the right side tank.
scientia non olet · About LEMON Manuals