Installation Procedure

IMPORTANT: Make sure the interconnect lined up and the interconnect seal is in place before installing the attachment screws.

Apply the dielectric compound to the spark plug boots and make sure no corrosion is present.
Install the ignition coil housing to the cam cover and the attachment bolts.

Fig 1: View Of Ignition Coil & Module Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the EI module and the attachment screws.
Tighten: Tighten the ignition coil housing bolts to 10 N.m (89 lb in).
Connect the EI module harness connector. Push in the connector until a click is heard and pull back to confirm a positive engagement.
Tighten: Tighten the EI module screws to 1.5 N.m (13 lb in).