LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Malibu Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.2L (L61) - Introduction >> Repair Instructions >> Knock Sensor (KS) Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Removing & Installing Knock Sensor
    GM895903Courtesy of GENERAL MOTORS CORP.
  1. Record the preset radio station.
  2. Turn the ignition OFF.
  3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  4. Remove the knock sensor (KS) harness connector.
  5. Remove the KS from the retaining clip by inserting a flat-bladed screwdriver between the connector and the clip while sliding the connector upward.
  6. Remove the KS.
scientia non olet · About LEMON Manuals