Inflatable Restraint Sensing and Diagnostic Module Programming and Setup

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The air bag indicator light may remain ON after the body control module (BCM), or sensing and diagnostic module (SDM) is replaced, and during the programming procedure for the BCM until after the procedure is completed, and the ignition key is cycled OFF and ON.

If the SDM is replaced you must perform the BCM reprogramming procedure in order for the BCM to relearn the new SDM ID. Refer to Body Control Module (BCM) Programming/RPO Configuration .