Installation Procedure

NOTE: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.
Use care in cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as sharp tools may damage the gasket surfaces.

Fig 1: Throttle Body Assembly

Courtesy of GENERAL MOTORS CORP.

Clean the gasket surface on the intake manifold and the throttle body assembly.
Install a new gasket, if necessary.
Install the throttle body assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the throttle body retaining nuts and bolts.
Tighten: Tighten the throttle body retaining nuts and bolts to 28 N.m (21 lb ft).
Connect the throttle body coolant bypass hoses.
Connect the heater pipe nut at the throttle body.

Fig 2: View Of IAC Valve Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the IAC valve electrical connector.

Fig 3: View Of TP Sensor & Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the TP sensor electrical connector.

Fig 4: View Of Accelerator Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Install the accelerator controls cable bracket. Refer to Accelerator Controls Cable Bracket Replacement .

Fig 5: Identifying Air Intake Duct

Courtesy of GENERAL MOTORS CORP.

Install the air intake duct. Refer to Air Cleaner Intake Duct Replacement .
Refill the coolant. Refer to Draining and Filling Cooling System in Engine Cooling.

IMPORTANT: The throttle should operate freely without binding between full closed and wide open throttle.

Inspect for complete throttle opening and closing positions by operating the accelerator pedal. Also inspect for poor carpet fit under the accelerator pedal.