LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Venture LS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.4L - Introduction >> Repair Instructions >> Throttle Body Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Identifying Air Intake Duct
    GM69062Courtesy of GENERAL MOTORS CORP.
  1. Drain the coolant. Refer to Draining and Filling Cooling System in Engine Cooling.
  2. Remove the air intake duct. Refer to Air Cleaner Intake Duct Replacement .
    3. Fig 2: View Of IAC Valve Electrical Connector
    GM69056Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the idle air control (IAC) valve electrical connector.
    4. Fig 3: View Of TP Sensor & Electrical Connector
    GM69065Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the throttle position (TP) sensor electrical connector.
    5. Fig 4: View Of Accelerator Cable Bracket
    GM12689Courtesy of GENERAL MOTORS CORP.
  5. Remove the accelerator control cable bracket. Refer to Accelerator Controls Cable Bracket Replacement .
    6. Fig 5: Throttle Body Assembly
    GM12688Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the throttle body coolant bypass hoses.
  7. Disconnect the heater pipe nut at the throttle body.
  8. Remove the nuts and bolts holding the throttle body to the intake manifold.
  9. Remove the throttle body assembly.
  10. Remove the old gasket.
scientia non olet · About LEMON Manuals