Front Toe Adjustment
- Remove the small seal clamp from the inner tie rod boot.
- Position the steering wheel in the straight ahead position.
- Loosen the hex nut on the tie rod (2). Turn the tie rod shaft (1) in order to obtain the proper toe angle. Refer to Wheel Alignment Specifications .
- Confirm the number of threads showing on each tie rod end is nearly equal.NOTE: Refer to Fastener Notice .
- Confirm that the tie rod ends (3) are square before you tighten the lock nuts (2).
Tighten: Tighten the hex nuts at the tie rod ends to 70 N.m (52 lb ft).
IMPORTANT: Ensure the seals do not twist. - Install the seal clamps.