Remote Control Door Lock Receiver Replacement

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Remote Control Door Lock Receiver

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1	Plate Assembly, Instrument Panel (I/P) Tip: Remove the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
2	Screws, Remote Control Door Lock Receiver Bracket (Qty: 3) Tighten: 3 N.m (27 lb in)
3	Bracket, Remote Control Door Lock Receiver
4	Receiver, Remote Control Door Lock Tip: Release the retaining clips to remove the receiver from the bracket. Reprogram the receiver. Refer to Remote Control Door Lock Receiver Programming and Setup (Domestic, Canada, and Japan) or Remote Control Door Lock Receiver Programming and Setup (Export) in Programming and Setup.