LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Computer/Integrating Systems) >> Diagnostic Information and Procedures >> DTC B1475 >> Component Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Testing

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Rap Relay Test

  1. Ignition OFF, disconnect the RAP relay.
  2. Test for 70-110 ohms of resistance between terminals 85 and 86.
    • If the resistance is not within the specified range, replace the relay.
  3. Test for infinite resistance between the following terminals:
    • 30 and 86
    • 30 and 87
    • 30 and 85
    • 85 and 87
    • If less than infinite, replace the relay.
  4. Install a 20-amp fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for less than 2.0 ohms of resistance between terminals 30 and 87.
    • If greater than 2.0 ohms, replace the relay.
scientia non olet · About LEMON Manuals