LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Gear Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the stabilizer shaft. Refer to Stabilizer Shaft Replacement (FWD) or Stabilizer Shaft Replacement (AWD) in Front Suspension.
  3. Disconnect the tie rod ends from the steering knuckles. Refer to Rack and Pinion Outer Tie Rod End Replacement .
  4. Disconnect the steering intermediate shaft from the steering gear. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
  5. Use a utility stand in order to support the frame.
  6. Remove the frame rear bolts.
    7. NOTE: Do not lower the rear of the frame too far as damage to the engine components nearest to the cowl may result.
  7. Use the utility stand in order to lower the frame and the powertrain.
  8. Remove the power steering gear heat shield. Refer to Power Steering Gear Heat Shield Replacement .
    9. Fig 1: View Of Power Steering Gear Cooler Pipe
    GM417967Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the power steering gear cooler pipe from the steering gear.
    10. Fig 2: View Of Power Steering Lines And Power Steering Gear
    GM417973Courtesy of GENERAL MOTORS CORP.
  10. Disconnect the power steering gear pressure hose from the power steering gear.
    11. Fig 3: Exploded View Of Power Steering Gear
    GM294314Courtesy of GENERAL MOTORS CORP.
  11. Remove the power steering gear bolts and nuts.
  12. Remove the power steering gear through the vehicle left side wheel opening.
scientia non olet · About LEMON Manuals