LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pressure Pipe/Hose Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the power steering pressure hose.
  2. Install the power steering hose to the hose retainer.
    3. Fig 1: View Of Power Steering Pressure Hose From Power Steering Pump
    GM417974Courtesy of GENERAL MOTORS CORP.
  3. Install the power steering hose retainer to the power steering gear.
    4. Fig 2: View Of Power Steering Lines And Power Steering Gear
    GM417973Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Connect the power steering hose to the steering gear.

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  5. Install the power steering gear hose clip.
  6. Install the power steering gear heat shield. Refer to Power Steering Gear Heat Shield Replacement .
  7. Use the utility stand in order to raise the frame rear.
  8. Install the frame rear bolts.

    Tighten:  Tighten the bolts to 165 N.m (122 lb ft).

  9. Remove the utility stand.
  10. Install the intermediate shaft to the steering gear. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
  11. Lower the vehicle.
  12. Connect the power steering pressure hose to the pump.

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  13. Install the drive belt. Refer to Drive Belt Tensioner Diagnosis in Engine Mechanical - 3.5L.
  14. Bleed the power steering system. Refer to Bleeding the Power Steering System .
scientia non olet · About LEMON Manuals