Scan Tool Data Definitions

The scan tool displays 0-17 volts. The level of battery voltage available at the power steering control module (PSCM).

The scan tool displays 0-17 volts. The level of ignition voltage available at the PSCM.

The scan tool displays 0-17 volts. The amount of voltage being supplied to the EPS motor while turning right.

The scan tool displays 0-17 volts. The amount of voltage being supplied to the EPS motor while turning left.

The scan tool displays 1-8. The number of the steering calibration the PSCM has chosen based on the VIN. All 8 of the steering calibrations for EPS are stored in the body control module (BCM).

The scan tool displays -20.70 N.m to +20.70 N.m (15.2 lb ft). The amount of torque being applied to the steering column shaft when turning the steering wheel. This signal voltage is from the detection coil of the torque sensor which is then converted to N.m by the PSCM. A - value indicates a left turn, a positive value indicates a right turn.

The scan tool displays 0-255 km/h (0-156 mph). The actual speed of the vehicle.