LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> HHR LS, Standard >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Gear Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the steering gear to the vehicle through the left wheelhouse opening.
    2. Fig 1: View Of Steering Gear Bolts
    GM851710Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the steering gear bolts.

    Tighten:  Tighten the bolts to 110 N.m (81 lb ft).

  3. Install the transmission rear mount. Refer to Transmission Rear Mount Replacement .
    4. Fig 2: View Of Intermediate Shaft-To-Steering Gear Pinch Bolt
    GM851655Courtesy of GENERAL MOTORS CORP.
  4. Connect the intermediate steering shaft to the steering gear.
  5. Install a new intermediate steering shaft bolt.

    Tighten:  Tighten the bolt to 34 N.m (25 lb ft).

    6. Fig 3: View Of Tie Rod End To Steering Knuckle
    GM854972Courtesy of GENERAL MOTORS CORP.
  6. Install the rack and pinion outer tie rod ends to the steering knuckles.
  7. Install new rack and pinion outer tie rod end nuts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft) plus 90 degrees.

  8. Install the front tire/wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  9. Adjust the front toe. Refer to Front Toe Adjustment .
scientia non olet · About LEMON Manuals