LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Lighting Systems) >> Repair Instructions >> Brake Pedal Position Sensor Calibration >> Calibration Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Calibration Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If the master brake cylinder has been replaced, verify that the correct pushrod is installed before attempting to calibrate the brake pedal position sensor.
  1. Turn ON the ignition, with the engine OFF.
  2. Install a scan tool, select the proper vehicle and options.
  3. Navigate to the BCM module setup menu, located in Vehicle Control Systems.
  4. Select the BPP Sensor Calibration procedure and follow the directions displayed on the screen.
scientia non olet · About LEMON Manuals