Rear Camber Adjustment

Rear Camber Adjustment

Removal Procedure




1. Raise the vehicle and provide suitable support. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assemblies.
3. Remove the strut from the vehicle.
4. Place the strut in a vise and file the upper strut-to-knuckle hole lateral - oblong. Compare the appearance of the holes before filing (2) with after filing (3).

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the strut to the vehicle.

Tighten the strut-to-knuckle bolts as far as to allow movement of the knuckle.

2. Install the tire and wheel assemblies.
3. Adjust the camber (1).

Tighten the strut-to-knuckle bolts to 120 N.m (89 lb ft).

4. Lower the vehicle.