LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Optra LS, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 1.8L (LDA) >> Repair Instructions >> Heated Oxygen Sensor 1 Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Identifying HO2S 1
    GM1289414Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: A special anti-seize compound is used on the oxygen sensor threads. This compound consists of a liquid graphite and glass beads. The graphite will burn away, but the glass beads will remain, making the sensor easier to remove. New or service sensors will already have the compound applied to the threads. If a sensor is removed from any engine and if for any reason it is to be reinstalled, the threads must have anti-seize compound applied before reinstallation.
  1. Coat the threads of the HO2S 1 with an anti-seize compound, if needed.
    2. NOTE: Refer to Fastener Notice .
  2. Install the HO2S 1 to the exhaust manifold.

    Tighten:  Tighten the oxygen sensor to 42 N.m (31 lb ft)  .

  3. Connect the HO2S 1 connector.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals