Component Testing
- Ignition OFF, disconnect the harness connector at the crankshaft position (CKP) sensor.
- Test for 460-620 ohms of resistance between the signal terminal 2 and low reference terminal 1.
- If not within the specified range, replace the CKP sensor.
- Disconnect the fuel pump relay.
- Set the DMM to the AC voltage scale.
- Engine cranking, test for more than 1.4 ACV between the signal terminal 2 and the low reference terminal 1.
- If less than the specified range, replace the CKP sensor.
IMPORTANT:
If the CKP sensor lead is damaged in any way, replace the CKP sensor.