Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the crankshaft position (CKP) sensor.
- Ignition ON, test for 1.5-2.0 volts between the signal circuit terminal 2 and the low reference circuit terminal 1.
- If less than the specified range, test the applicable circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
- If greater than the specified range, test the applicable circuit for a short to voltage. If the circuit tests normal, replace the ECM.
- If all circuits test normal, test or replace the CKP sensor.
IMPORTANT:
If the CKP sensor lead is damaged in any way, replace the CKP sensor.