LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - Introduction >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Identifying Remote Power Steering Fluid Reservoir, Bracket & Bolts
    GM1856014Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine mount strut bracket. Refer to ENGINE MOUNT STRUT BRACKET REPLACEMENT - RIGHT SIDE .
  2. Remove the radiator inlet hose from the water outlet. Refer to Radiator Inlet Hose Replacement .
  3. Remove the power steering fluid reservoir bracket bolts (1).
  4. Remove and reposition the power steering fluid reservoir bracket (2) out of the way.
    5. Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860429Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the engine wiring harness electrical connector (8) from the bank 2 intake camshaft position (CMP) sensor (7).
    6. Fig 3: View Of CMP Sensor Bolt & Sensor
    GM1860459Courtesy of GENERAL MOTORS CORP.
  6. Remove the CMP sensor bolt and sensor (3).
scientia non olet · About LEMON Manuals