Rear Object Alarm Module Replacement

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Object Alarm Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the left rear quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Acadia/OUTLOOK with TB4) or Quarter Lower Rear Trim Panel Replacement (Acadia/OUTLOOK with TB5) or Quarter Lower Rear Trim Panel Replacement (Enclave with TB4) or Quarter Lower Rear Trim Panel Replacement (Enclave with TB5) or Quarter Lower Rear Trim Panel Replacement (Traverse with TB4) or Quarter Lower Rear Trim Panel Replacement (Traverse with TB5) . Remove the liftgate actuator (if equipped). Refer to Liftgate Actuator Replacement .
1	Communication Interface Module Bracket Procedure Disconnect the body harness from the bracket as required. Loosen the bracket fasteners to remove the bracket from the slotted holes. Disconnect the electrical connectors.
2	Rear Object Alarm Module Procedure: Refer to Control Module References Control Module References for programming and set up.

Callout

Component Name

Preliminary Procedures

Remove the left rear quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Acadia/OUTLOOK with TB4) or Quarter Lower Rear Trim Panel Replacement (Acadia/OUTLOOK with TB5) or Quarter Lower Rear Trim Panel Replacement (Enclave with TB4) or Quarter Lower Rear Trim Panel Replacement (Enclave with TB5) or Quarter Lower Rear Trim Panel Replacement (Traverse with TB4) or Quarter Lower Rear Trim Panel Replacement (Traverse with TB5) .
Remove the liftgate actuator (if equipped). Refer to Liftgate Actuator Replacement .

Communication Interface Module Bracket

Procedure

Disconnect the body harness from the bracket as required.
Loosen the bracket fasteners to remove the bracket from the slotted holes.
Disconnect the electrical connectors.

Rear Object Alarm Module
Procedure:
Refer to Control Module References Control Module References for programming and set up.