LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2010 >> HHR SS, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.0L - Repair Instructions >> Repair Instructions >> Fuel Line Replacement - Chassis >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Fuel Feed Line
    GM1625417Courtesy of GENERAL MOTORS CORP.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (High Pressure Side)  or Fuel Pressure Relief (Without CH 48027)  or Fuel Pressure Relief (With CH 48027) .
  2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  3. Disconnect the fuel feed pipe from the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
  4. Cap or plug the fuel pipe and the engine fuel rail to prevent contamination.
    5. Fig 2: EVAP Line
    GM1625606Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the evaporative emission (EVAP) pipe from the purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Cap or plug the EVAP pipe in order to prevent contamination.
  7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  8. Remove the evaporative emission (EVAP) canister, if necessary. Refer to Evaporative Emission Canister Replacement .
  9. Disconnect the fuel feed pipe quick connect fitting. Refer to Plastic Collar Quick Connect Fitting Service .
    10. Fig 3: Fuel/EVAP/Brake Line Brackets
    GM1636707Courtesy of GENERAL MOTORS CORP.
  10. Remove the brake lines from the fuel/EVAP/brake line brackets.
  11. Remove the fuel/EVAP/brake line bracket nuts and remove the brackets from the body studs.
  12. Remove the fuel and EVAP lines from the vehicle.
  13. Open the brackets and remove the fuel feed pipe.
scientia non olet · About LEMON Manuals