LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Camaro LS, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L - Repair Instructions >> Repair Instructions >> Fuel Tank Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the following components if fuel tank replacement was necessary:
    1. Fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement - Right Side .
    2. Fuel level sensor. Refer to Fuel Level Sensor Replacement - Left Side .
    2. Fig 1: Fuel Tank Strap Bolts
    GM2195196Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Use a suitable jack and install the fuel tank.
  3. Install the fuel tank strap bolts (1) and tighten to 50 N.m (37 lb ft).
    4. Fig 2: Fuel Tank Electrical Connector, Fuel Feed Line & Evaporative Emission Line
    GM2195093Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel tank electrical connector (1).
  5. Connect the fuel feed line (2) and evaporative emission line (3). Refer to Plastic Collar Quick Connect Fitting Service  and Metal Collar Quick Connect Fitting Service .
    6. Fig 3: Hose Clamp, Filler Tube & Evaporative Emission Line
    GM2195040Courtesy of GENERAL MOTORS CORP.
  6. Install the filler tube (2) and tighten the hose clamp (1) to 4 N.m (35 lb in) and remove the filler tube (2).
  7. Connect the evaporative emission line (3). Refer to Plastic Collar Quick Connect Fitting Service .
    8. Fig 4: Evaporative Emission Lines & Vent Solenoid Electrical Connector
    GM2195033Courtesy of GENERAL MOTORS CORP.
  8. Connect the evaporative emission lines (1). Refer to Plastic Collar Quick Connect Fitting Service .
  9. Connect the vent solenoid electrical connector (2).
  10. Connect the parking brake cables at the calipers. Refer to Parking Brake Rear Cable Replacement .
  11. Install the rear suspension support and tighten to specifications. Refer to Rear Suspension Support Replacement .
  12. Install the park brake cables. Refer to Parking Brake Rear Cable Replacement .
  13. Install the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement .
  14. Install the exhaust system for access. Refer to Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (Vehicle Service) .
  15. Install the right rear wheel. Refer to Tire and Wheel Removal and Installation
  16. Refill the fuel tank.
  17. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals