LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Programming And Setup - All Systems) >> Repair Instructions >> Rear Seat Heater Control Module Programming and Setup >> Rear Seat Heating Control Module Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Seat Heating Control Module Programming

WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

To program and setup an existing or new replacement rear seat heating control module, perform the following procedure:

  1. With a scan tool, access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) 
  2. On the SPS Supported Controllers screen, select Rear Seat Heating Control Module - Programming and follow the on-screen instructions.

If the rear seat heating control module fails to accept the program, verify all scan tool and rear seat heating control module connections are secure.

NOTE:

After programming is completed, perform the following to avoid future misdiagnosis:

  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. With a scan tool, clear all DTC's from all modules.
scientia non olet · About LEMON Manuals