LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Camaro LS, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L - Repair Instructions >> Repair Instructions >> Fuel Pipe Shield Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Intake Manifold & Cylinder Bolts
    GM1977749Courtesy of GENERAL MOTORS CORP.
  1. Position the fuel pipe shield behind the high pressure fuel pump. Take care not to damage the insulation behind the shield.
  2. Install the fuel pipe shield to cylinder bolt (1). Hand tighten at this time.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the fuel pipe shield to intake manifold bolts (1).
    • Tighten the fuel pipe shield to manifold bolts to 23 N.m (17 lb ft).
    • Tighten the fuel pipe shield to head bolt to 10 N.m (89 lb in).
  4. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement - Front .
  5. Install the cross vehicle brace.
scientia non olet · About LEMON Manuals