LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Caprice >> Repair and Diagnosis >> Engine Performance >> System >> Data Communications System >> Diagnostic Information and Procedures >> DTC U2099 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

NOTE:

Use the schematic to determine which control modules are on the BCM communications enable circuit 19, X3.

  1. Ignition OFF, disconnect the harness connector at the most easily accessible control module on the K9 BCM communication enable relay control circuit.
  2. Ignition ON, retest for current DTCs. DTC U2099 should remain current.
    • If the DTC becomes history, replace the control module that was just disconnected.
  3. With the prior control modules disconnected, repeat steps 1 and 2 for each control module on the circuit except the K9 BCM.
  4. Ignition OFF, disconnect the X3 harness connector at the K9 BCM.
  5. Test for infinite resistance between the serial data communication enable circuit terminal 19 X3 and ground.
    • If less than infinite resistance, repair the communication enable relay control circuit for a short to ground.
  6. If all circuits tests normal, replace the K9 BCM.
scientia non olet · About LEMON Manuals