Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative.

Paint the rear object sensor. Refer to Basecoat/Clearcoat Paint Systems .
Ensure the paint does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals. Refer to Paint Gauges .

Fig 1: Identifying Rear Object Sensor Housing

Courtesy of GENERAL MOTORS CORP.

Insert the sensor into the housing.
Connect the electrical connector to the rear object sensor.
Install the rear bumper fascia. Refer to Rear Bumper Fascia Replacement .