Circuit/System Testing
- Ignition OFF, disconnect the X2 harness connector at the PSCM.
- Verify that a test lamp does not illuminate between the ignition circuit terminal 6 and ground.
- If the test lamp illuminates, test the ignition circuit for a short to voltage. If the circuit tests normal, replace the BCM.
- Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 6 and ground.
- If the test lamp does not illuminate, test the ignition circuit for a short to ground or and open/high resistance. If the circuit tests normal, replace the BCM.
- If all circuits test normal, replace the steering column.