LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Impala LT >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.5L - Repair Instructions >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: View Of PCV Tube & Air Inlet Duct
    GM1608799Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Remove the left inner fender brace. Refer to Front Fender Upper Diagonal Brace Replacement .
  3. Loosen the air cleaner outlet duct clamp at the throttle body.
  4. Remove the air cleaner outlet duct from the throttle body.
  5. Disconnect the positive crankcase ventilation (PCV) tube from the air inlet duct. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 2: Upper Air Cleaner Housing
    GM1554546Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the mass air flow (MAF) sensor electrical connector.
  7. Remove the upper air cleaner housing from the lower housing. Disengage the tabs on the upper housing from the slots on the lower housing.
  8. Without disconnecting the powertrain control module (PCM) connectors, remove the PCM and the harness from the lower air cleaner housing.
  9. Without disconnecting the transmission control module (TCM) connectors, remove the TCM and the harness from the lower air cleaner housing.
  10. Loosen the air cleaner outlet duct clamp at the air cleaner assembly.
  11. Remove the air cleaner outlet duct from the air cleaner.
    12. Fig 3: Lower Air Cleaner Housing
    GM1554550Courtesy of GENERAL MOTORS CORP.
  12. Remove the lower air cleaner housing by pulling the housing from the 2 rubber grommets on the inner rail.
  13. Inspect the air cleaner housing assembly for signs of damage and replace if necessary.
scientia non olet · About LEMON Manuals