Diagnostic Aid
WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
This is an informational DTC set by the engine control module. It is set to provide an indication that the active safety control module will not be able to perform as intended. Diagnose any other DTCs first.
NOTE:
During normal diagnostic and/or repair verification technicians may find that a "Service Driver Assist System" message may be displayed by the active safety control module. Do not replace the active safety control module for this condition.
If the Service Driver Assist System message is on with no DTCs set, perform the following steps:
- Remove the key from the ignition, open and close the driver's door to turn off retained accessory power, and wait 60 seconds.
- Ignition ON, if the Service Driver Assist message is still present, operate the vehicle at speeds greater than 15 km/h (10 mph) to complete the self test. The active safety control module should request the message to turn OFF.
- If the telltales remain ON with no DTCs set after the drive cycle, disconnect the battery for at least 60 seconds then reconnect the battery.
- Operate the vehicle at speeds greater than 40 km/h (25 mph), the active safety control module should request all telltale indicators to turn OFF.