LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Traverse LS, AWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Fluid Reservoir Bracket Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    CAUTION:

    Refer to Fastener Caution .

    Fig 1: Identifying Power Steering Fluid Reservoir Bracket & Bolts
    GM2075295Courtesy of GENERAL MOTORS CORP.
  1. Install the remote power steering fluid reservoir bracket (2).
  2. Install the remote power steering fluid reservoir bracket bolts (1) and tighten to 9 N.m (80 lb in).
    3. Fig 2: View Of Power Steering Fluid Reservoir Outlet Hose & Clamp
    GM1856009Courtesy of GENERAL MOTORS CORP.
  3. Connect the power steering fluid reservoir outlet hose (1).
    4. Fig 3: Identifying Power Steering Reservoir Inlet Hose & Clamp
    GM1856010Courtesy of GENERAL MOTORS CORP.
  4. Connect the power steering reservoir inlet hose (1).
  5. Clean all excess fluid from the vehicle and remove the drain pans.
  6. Install the right side engine mount strut bracket. Refer to ENGINE MOUNT STRUT BRACKET REPLACEMENT - RIGHT SIDE .
  7. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
  8. Install the fuel injector sight shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT .
scientia non olet · About LEMON Manuals