LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Volt >> Repair and Diagnosis >> Engine Performance >> System >> Data Communications System >> Diagnostic Information and Procedures >> DTC U1833 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

    NOTE: Use the schematic to identify the following:
    • Control module location on the chassis high speed GMLAN serial data circuits
    • Control module B+, ignition, ground, communication enable and serial data circuit terminals
  1. Ignition OFF, disconnect the harness connector at the K17 electronic brake control module (EBCM).
  2. Test for less than 10 Ω between each ground circuit terminal and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. If equipped, ignition ON, verify that a test lamp illuminates between each B+ circuit terminal and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit fuse is open, test the control circuits of the K17 EBCM for a short to ground. If the circuits test normal, replace the K17 EBCM.
  4. If equipped, ignition ON, verify that a test lamp illuminates between each ignition circuit terminal and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance. If the circuit fuse is open, test the control circuits of the K17 EBCM for a short to ground. If the circuits test normal, replace the K17 EBCM.
  5. If equipped, ignition ON, verify that a test lamp illuminates between the wakeup circuit terminal and ground.
    • If the test lamp does not illuminate, test the entire circuit, including the B+ circuit to the K114B hybrid powertrain control module 2, for an open/high resistance or short to ground. If the circuits test normal, replace the K114B hybrid powertrain control module 2.
  6. Ignition OFF, disconnect the harness connector at the control module setting the DTC.
  7. Ignition OFF and all vehicle systems OFF, all keys at least 3 meters away from vehicle, all access doors closed. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 1 Ω in each chassis high speed GMLAN serial data circuit between the K17 EBCM and the control module setting the DTC.
    • If greater than the specified range, test the serial data circuit for an open/high resistance between the K17 EBCM and the control module setting the DTC.
  8. If all circuits test normal, replace the K17 EBCM.
scientia non olet · About LEMON Manuals