Steering Angle Sensor Centering

The steering angle sensor does not require a centering often. Centering of the steering angle sensor might be required after certain service procedures are performed. Some of these procedures are as follows:

• Electronic brake control module (EBCM) replacement
• Steering angle sensor replacement
• Steering gear replacement
• Steering column replacement
• Collision or other physical damage

The steering angle sensor centering procedure can be completed with a scan tool using the following steps:

1. Using the steering wheel, align the front wheels forward.
2. Apply the parking brake, or set the transmission in the P position.
3. Install the scan tool to the data link connector.
4. Ignition ON, engine OFF
5. Select Steering Wheel Angle Sensor Reset in the Steering Wheel Angle Sensor Module Configuration/Reset Functions list.
6. Follow the scan tool directions to complete the reset procedure.
7. Select Steering Wheel Angle Sensor Learn in the Steering Wheel Angle Sensor Module Configuration/Reset Functions list.
8. Follow the scan tool directions to complete the learn procedure.
9. Clear any DTCs that may be set.