Circuit/System Verification

C0475

1. Ignition OFF, disconnect the X1 harness connector at the Power Steering Gear.
2. Test for less than 1 Ω between the ground circuit terminal 2 and ground.
   • If greater than the specified range, test the ground circuit for an open/high resistance.
3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 1 and ground.
   • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
4. If all circuits test normal, replace the Power Steering Gear.

   Refer to Steering Gear Replacement (L99, LFX, LS3, N41) , Steering Gear Replacement (LSA, NV9) .