Installation Procedure
- Apply a few drops of clean engine oil to the male pipe end.
- Push both sides of the fitting together in order to snap the retaining tabs into place.
- Once installed, pull on both sides of the fitting in order to make sure the connection is secure.
- Install the retainer to the quick connect fitting.
WARNING:
In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.